Question 1

What is the difference between Dagger-Guard and Ultra-Guard?

Accepted Answer

Both are rated at 1,000 hours of ASTM B117 salt spray. Dagger-Guard is a three-layer coating for general exterior, metal building, concrete and masonry work. ACQ Dagger Ultra-Guard is a zinc/chromate substrate with a proprietary organic topcoat specifically approved for ACQ pressure-treated lumber, so it is the one for decks and fencing. ACQ Dagger-Pro Ultra-Guard doubles that again to 2,000 hours.

Question 2

Which drill point do I need?

Accepted Answer

Match the point to the steel thickness. A #1 stitch point joins two layers of light gauge. #2 handles 0.036 to 0.105 inch. #3 covers 0.105 to 0.175 inch. #4 goes to 0.312 inch, and #5 drills structural steel up to 1/2 inch. Type 17 is not a drill point at all - it is an auger point for wood that starts without a pilot hole.

Question 3

What finish should I use in Southwest Florida salt air?

Accepted Answer

Plain zinc is an indoor finish here - it is rated at 24 hours of salt spray. For anything exterior, start at Dagger-Guard or ACQ Ultra-Guard at 1,000 hours. Within sight of salt water, go to 305 stainless, and for direct exposure such as docks and seawalls use 316 stainless.

Question 4

Can I mix stainless fasteners with aluminum?

Accepted Answer

With care. Stainless and aluminum sit far enough apart on the galvanic series that a wet, salty environment will corrode the aluminum around the fastener. That is exactly what the aluminum-industry line and IFI’s Corrosion Between Metals guide address - use the coated aluminum-industry screws and matching bonded washers rather than bare stainless into aluminum.

Concrete Screws

Shop Concrete Screws

What we stock in concrete screws

Finishes in this category

More from the DAGGERZ line